Skip to content

FAQ

In our FAQ you will find answers and support for the most frequently asked customer questions regarding our Race Navigator systems. Please use the FAQ as your first point of contact for technical questions – in many cases you will find a suitable answer here.

DOES THE RN LITE HAVE AN INTERNAL BATTERY?

Yes, the device has an integrated battery. The battery in the device is used to ensure video processing even after an incident. For example, after an accident, it protects against a possible power failure from the external power supply. The battery is not used for normal use of the RN LITE without an external power supply.

If the remaining recording time is less than one hour, the system displays a message in the top toolbar. It is a yellow triangle with an exclamation mark in the center. You can check the available storage capacity under : SETTINGS -> RN DEVICE -> STATUS.

CAN OTHER CAMERAS BE CONNECTED TO THE RN LITE?

No, only one camera can be connected to the RN LITE.

CAN THE MEMORY CAPACITY OF THE RN LITE BE EXPANDED?

No, the RN LITE is only available with the 64GB memory version.

I HAVE NO GPS RECEPTION WITH THE RN LITE.

1.) Please check the connection of the external GPS antenna on the device. Tighten the union nut on the connection hand-tight.

2.) Please check the laying of the cable and if it is bent or damaged.

3.) Please check the installation of the GPS antenna. We generally recommend the installation outside on the roof. The antenna has an integrated magnetic base.
It may help to disconnect and reconnect the connector or to restart the system.

WHEN IS THE RN LITE MEMORY FULL?

If the available remaining recording time is less than one hour, the system displays a message in the upper toolbar. It is a yellow triangle with an exclamation mark in the middle. You can check the available memory capacity under : SETTINGS -> RN DEVICE -> STATUS.

THE RN LITE CANNOT BE SWITCHED ON.

Please check the power supply. If in doubt start the engine. You can see at the cigarette lighter plug at a green LED that 12V voltage is available at the plug. The RN ONE MKII is switched on by holding the ON/OFF switch on the side for 2 seconds.

In case of extreme sunlight the temperature of the RN ONE can rise strongly. If this happens, a safety feature will operate to protect the RN ONE from thermal damage and it may not turn on. In case of overheating, it is necessary to disassemble the RN ONE and remove it from direct sunlight to cool it down. After a short time, the RN ONE can then be switched on again.

After the intro has been played, the start screen appears and the unit is ready for use. In addition, the Home button on the top will blink green during the boot process. If it is constantly green, the system is ready for use.